THE PERFECT FINISH
Special Buffing & Lamellar Wheels
The original Riepe® fabric and fabric-sisal buffing wheels have been developed in practice for use especially with thick and thin edge.
Fabric buffing wheels
The fabric buffing wheels offered by us are distinguished by a strong fabric quality. Composed of 2 x 14 layers of fabric they are extremely strong. As a result, a spreading of the buffing wheels on the edge radius is avoided.
In connection with the special Cleaning Agent LP163/93®, the edge radius is polished so that its sheen matches that of the surface. The life of the buffing wheels is also considerably increased by the Cleaning Agent LP163/93®.
Result:
Material re-finishing |
|
Edge polishing |
|
Reduction in stress whitening |
|
Edgeband radius re-matches the sheen of the surface |
Available size:
Outer diameter mm | 120 / 150 / 160 / 190 |
Width mm | 11 / 20 / 25 / 27 |
Boreholes mm | 11 / 19(Hex.) / 40 / 50 / 55 |
(special sizes on request)
Fabric-Sisal-Lamellar wheels 3:1 ratio
The fabric-sisal-lamellar wheels are brushes with a cast mounting core. The lamellar are composed of the following ratio: 3 x fabric and 1 x sisal. The cloth in the lamellar serves to remove the previously applied special Cleaning Agent LP163/93®. The sisal is used to polish the edge banding.
The use of the fabric-sisal-lamellar wheels while processing all types of thermoplastic edges in combination with the special Cleaning Agent LP163/93® leads to the following result:
Material re-finishing |
|
Edge polishing |
|
Reduction in stress whitening |
|
Edgeband radius re-matches the sheen of the surface |
The fabric-sisal-lamellar wheels are suitable for all types of thermoplastic edgings. In addition, they have a very long operating life.
The use of the fabric-sisal-lamellar wheels while processing thin edges leads to the following result:
Removal of the protruding edging material |
|
Trimming of the edge band (smooth) |
Available size:
Outer diameter mm | 120 / 160 / 190 |
Width mm | 20 / 25 |
Boreholes mm | 11 / 19(Hex.) / 40 / 50 / 55 |
(special sizes on request)
Buffing wheel adjustment
- approx. 3° inclined to the board (vertical)
- approx. 10° inclined to the support (if possible)
- approx. 1400 rpm motor speed (if possible)
- No oscillation
- Rotational direction in synchronous run